Before the actual concrete cleaning process begins, check first to see whether you already have the following things: Broom, dustpan, mop, bucket, scrub brush, and dish washing detergent. If not, you can purchase them from a hardware store. Make sure that you have lukewarm water so that you don’t cause any damage to the finish of the concrete when cleaning. You also need a lot of elbow grease so that you won’t be spending time tweezing out the remaining bits of dirt when doing the actual cleaning.
To use your concrete cleaning chemical, mix the proper chemical with water and apply it to the surface that you want to remove the stain from. Some cleaners will be stronger than others. For example, grease removers are usually stronger than acid cleaners which is why you must choose the right one for the job at hand. Remember that the grease stain is usually more stubborn than the oil so it may take several passes of the cleaner for it to be completely removed.
Next, you should use the mop or brush to apply the bleach. The strength of the bleach that you use will depend on the severity of the stain. The more severe the stain the more bleach you should use. Using too much bleach can also damage the concrete. Using only enough warm water and detergent on the concrete will help eliminate the stains as well.
Once you have used the bleach to whiten the concrete, you are now ready to use your pressure washer to do the actual scrubbing. The pressure washer has an internal suction system that will help suck up all of the dirt and grime that was stuck in your Concrete cleaner. You will need to do this quickly so it is not a messy process. If you need to do a lot of scrubbing you can use a broom or a dustpan with wide ends to move the dirt around. Using a regular floor scrubber or carpet extractor can help you reach high areas where concrete cleaners cannot reach.
When you are finished with the scrubbing make sure to let the Concrete cleaners dry completely before you apply another coat of bleach. Some Concrete cleaners are extremely harsh and using harsh chemicals on concrete floors can permanently damage them. Some cleaners contain abrasive substances that can wear away at your flooring. The better quality Concrete cleaners will use only safe ingredients that won’t damage your floors.
Another Concrete cleaning tip is to never paint over rust stains. If you already have rust stains on your concrete walkway or driveway then you need to use some type of preventative treatment. Sometimes just getting the stain out can be too difficult. Some people will use acid to remove the rust but this can be toxic. You may also want to go with a rust stain protector. These protect your concrete and keep it looking great.
There are other Concrete cleaning methods to get stains out of your concrete surfaces. You should try these methods first before you think about chemical products. A mixture of water, baking soda, hydrogen peroxide and mild soap is a great way to remove grease stains from concrete surfaces. When scrubbing you should only use soft scrub brushes because hard bristles can scratch the surface.